For the Starboard Quick Lock II fuselages you can purchase a spacer set to increase the distance between the wings by 20 mm and therefore also to be able to vary the position of the wings in relation to the mast.
(S) for trimming the tail piece and (L) for the front wing.
DESIGN TO INNOVATE:
ADJUST YOUR FUSELAGE LENGTH
The new Quick Lock II comes with 20mm spacers that allow you to extend the foil's wing-base by up to 40mm
Trimming Recommendations:
| 1 - No spacers | Maximum maneuverability |
| 2 - Tail spacer | More flight stability, less maneuverability |
| 3 - Front spacer | More power and upwind drive |
| 4 - Both spacers | More power and maximum stability, minimum maneuverability |
WING-BASE MEASUREMENTS
With Quick Lock II, our wing-bases can be adjusted up to 4cm using two 2cm spacers.
E-Type, S-Type and Glider wing-bases are measured using the 36cm tail piece that comes with the wing sets. 31cm and 41cm tail pieces are available as an upgrade item.
The Glider Pro's tail piece can be cut up to 8cm shorter for pro-riders who look for the shortest wing-base.
Wing-base measurements will vary depending on the actual front and tail wing sizes used.
Starboard Foils har i løpet av få år etablert seg som den ledende foilprodusenten innenfor flere vannsportkategorier.
